General Assist Technical Reference
J-IIIL (Three Phase) – DIP Switch & Refrigerant Circle Addressing
Models Covered
AJY072LELAH, AJY090LELAH and AJY108LELAH.
AJY072LELAH, AJY090LELAH and AJY108LELAH.
DIP Switch Reference
The reference chart below shows the required positions for Set-1, Set-2 and Set-5, together with the refrigerant circle address settings for the J-IIIL three-phase outdoor units listed above.
Set-3 and Set-4
There is no standard DIP switch setting shown for Set-3 and Set-4 in this reference. Set-3 is used for master/slave configuration in combination installations, while Set-4 is reserved for development use.
There is no standard DIP switch setting shown for Set-3 and Set-4 in this reference. Set-3 is used for master/slave configuration in combination installations, while Set-4 is reserved for development use.
Important
Isolate power before changing DIP switches or refrigerant circle addresses. Confirm all settings against the applicable system design and service documentation before commissioning.
Isolate power before changing DIP switches or refrigerant circle addresses. Confirm all settings against the applicable system design and service documentation before commissioning.
